ARMOUR ULTRA (iTank T) Setup Guide: Wattage, Coils and Airflow

By vaporesso | Published: 2026-11-02

Category: How-to Guides

Get your ARMOUR ULTRA (iTank T) running right the first time. Follow these steps for coil priming, wattage settings, and airflow adjustment.

Quick answer

Prime the iTank T coil thoroughly, start at the low end of its recommended wattage range, and adjust airflow to a slightly restricted draw before gradually increasing power. This sequence prevents dry hits and gives you a reliable baseline for the ARMOUR ULTRA.

Why the first tank matters more than the mod

The ARMOUR ULTRA’s 5500mAh battery and IP68/IP69K/MIL-STD-810H ratings protect the device from drops and water, but they do nothing for a poorly primed coil. Most early burnt tastes come from firing a dry wick, not from the mod itself. Take five extra minutes on the iTank T coil before you explore wattage or airflow.

When to ignore the urge to crank wattage

Higher wattage shortens coil life and can scorch e-liquid if the wick is not fully saturated. If you chain vape or use thick high-VG liquids, stay closer to the coil’s lower recommended range even after break-in. The ARMOUR ULTRA will happily fire higher, but the iTank T coil sets the real ceiling.

Step-by-step ARMOUR ULTRA (iTank T) setup

Prime the iTank T coil: Place a few drops of e-liquid directly onto the exposed cotton of a new coil, then install it in the tank and fill the tank. Let it sit for at least 10–15 minutes before firing. Skipping the wait is the most common cause of a burnt first puff.
Start at low wattage: Set the ARMOUR ULTRA to the lowest wattage printed on the coil. Take two or three short puffs without inhaling deeply to ease the wick in. If the vapor tastes dry or harsh, stop and re-prime before continuing.
Adjust airflow to a slightly restricted draw: Close the iTank T airflow ring about halfway, then open it gradually until the draw feels comfortable. A tighter draw concentrates flavor; a looser one produces more vapor. Set airflow before raising wattage so you can judge flavor without overpowering it.
Increase wattage in small steps: Raise power in 2–5 watt increments, taking a puff after each change. Stop at the highest setting where the vapor stays smooth and the flavor remains clean. If you taste burnt notes, drop back 5 watts and stay there for the rest of the tank.
Lock in your settings and monitor: Once you find a comfortable wattage and airflow, note them. After the first full tank, check the coil for darkening or gurgling and adjust one variable at a time. Change only wattage or airflow per tank, not both, to learn what your coil prefers.

Product facts

ARMOUR ULTRA (iTank T): Built-in 5500mAh battery, roughly equivalent to two 18650 cells, with IP68, IP69K, and MIL-STD-810H protection. You get long runtime and drop/water resistance, so the setup priority shifts to coil priming and wattage rather than battery safety.
ARMOUR ULTRA (iTank T)